How to Use Camp Cot Feet Covers to Protect Your Tent Floor

By TETON Sports | Published: 2026-10-29

Category: How-to Guides

Learn how to install and use TETON Sports Camp Cot Feet Covers to keep your tent floor clean and scratch-free during camping trips.

Quick answer

Slip TETON Sports Camp Cot Feet Covers over each cot leg to prevent dirt, mud, and scratches from damaging your tent floor. The tethered elastic connector keeps them secure during use.

Why protect your tent floor

Tent floors are vulnerable to punctures and abrasion from cot legs, especially on uneven ground or when dirt and debris get trapped underneath. Using feet covers adds a protective barrier that extends the life of your tent and keeps your sleeping area cleaner.

When to use cot feet covers

Use them every time you set up your cot inside a tent or on any delicate surface. They are especially helpful in muddy or sandy conditions, where small particles can grind into the floor fabric. Avoid using them on extremely wet surfaces where water might pool inside the covers.

Steps to install camp cot feet covers

Step 1: Gather your covers: Unpack the set of 6 TETON Sports Camp Cot Feet Covers. Check that the elastic connectors are intact and free of damage. Inspect the covers before use to avoid tears that could reduce protection.
Step 2: Lift one cot leg: Raise one corner of the cot just enough to slide the cover over the leg. Do not lift the cot higher than necessary to avoid stressing the frame. Lifting too high can strain the cot frame; lift only a few inches.
Step 3: Slip the cover into place: Slide the cover over the cot leg until the bottom of the leg is fully inside the bootie. Ensure the cover sits flat against the leg. If the cover bunches up, it may not protect the floor evenly.
Step 4: Secure with the elastic connector: Wrap the tethered elastic connector around the leg or through the provided loop to hold the cover in place. Make sure it is snug but not overly tight. An overly tight connector can stretch the elastic over time.
Step 5: Repeat for all legs: Repeat steps 2–4 for each of the remaining five cot legs. Double-check that all covers are secure before laying down on the cot. Missing a cover on one leg can still scratch the tent floor.
Step 6: Remove and store after use: When packing up, lift each leg and slide the cover off. Shake out any dirt or debris, then store the covers in a dry place. Storing them damp can lead to mildew; let them air dry first.

Product facts

Camp Cot Feet Covers - 6 Shoes: TETON Sports Camp Cot Feet Covers are designed to protect against dirt, mud, and debris, and feature a tethered elastic connector for a secure fit. The elastic connector keeps the covers from slipping off during the night, so you don't have to readjust them after setting up your cot.
Camp Cot Feet Covers - 6 Shoes